Dining room chair slipcovers – Most dining room chairs are usually the same size, give or take a few inches. For this design, the chair was 44 inches high x 20 inches wide x about 22 inches deep. You need about 3 yards from the 45 inch wide screen to cover a standard size dining room chair. If you have an oversized dining table and chair set and your dining room chair is wider, you may consider using 60-inch wide fabric to ensure proper coverage.
To measure your dining room chair slipcovers, start with measure the length of dining room chair. From the back of your chair, measure up and over the back seat on the other side of the cushion and front and down to the floor in front. For width, measure the entire chair from the left side to the right, starting on the floor on one side and going over the seat down to the floor on the other side. If you choose wisely, a neutral style of fabric can give you plenty of use.
12 Photos Gallery of: Dining Room Chair Slipcovers Guide
Because it can take many actions that you add contrasting, interchangeable ropes, ribbons, strands and other finishes changing the look of your slipcover. Unless you are a good fabric cutter, when you are buying fabric for four chairs, be sure to add an extra half yard or yard of fabric to each chair in case you make a mistake. You can always use the extra for some nice napkins or placemats for coordinating. The satin ribbon adds a very festive touch for the dining room chair slipcovers. You can have enough tape or comparable trim on your sewing kit, and so dig a little.